हिंदी

Two cells of emf’s approximately 5V and 10V are to be accurately compared using a potentiometer of length 400 cm. - Physics

Advertisements
Advertisements

प्रश्न

Two cells of emf’s approximately 5V and 10V are to be accurately compared using a potentiometer of length 400 cm.

विकल्प

  • The battery that runs the potentiometer should have voltage of 8V.

  • The battery of potentiometer can have a voltage of 15V and R adjusted so that the potential drop across the wire slightly exceeds 10V.

  • The first portion of 50 cm of wire itself should have a potential drop of 10V.

  • Potentiometer is usually used for comparing resistances and not voltages.

MCQ
रिक्त स्थान भरें

उत्तर

The battery of potentiometer can have a voltage of 15V and R adjusted so that the potential drop across the wire slightly exceeds 10V.

Explanation:

The potential drop along the wires of potentiometer should be greater than emfs of cells.

In a potentiometer experiment, the emf of a cell can be measured if the potential drop along the potentiometer wire is more than the emf of the cell to be determined. Here, values of emfs of two cells are given as 5V and 10V, therefore, the potential drop along the potentiometer wire must be more than 10V.

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 3: Current Electricity - MCQ I [पृष्ठ १७]

APPEARS IN

एनसीईआरटी एक्झांप्लर Physics [English] Class 12
अध्याय 3 Current Electricity
MCQ I | Q 3.04 | पृष्ठ १७

वीडियो ट्यूटोरियलVIEW ALL [1]

संबंधित प्रश्न

Calculate force per unit length acting on the wire B due to the current flowing in the wire A.(See
Figure 2 below)


A wheel with 8 metallic spokes each 50 cm long is rotated with a speed of 120 rev/min in a plane normal to the horizontal component of the Earth’s magnetic field. The Earth’s magnetic field at the place is 0.4 G and the angle of dip is 60°. Calculate the emf induced between the axle and the rim of the wheel. How will the value of emf be affected if the number of spokes were increased?


Answer the following question.
Two bulbs are rated (P1, V) and (P2, V). If they are connected (i) in series and (ii) in parallel across a supply V, find the power dissipated in the two combinations in terms of P1 and P2.


Choose the correct alternative.

Five dry cells each of voltage 1.5 V are connected as shown in the diagram

What is the overall voltage with this arrangement?


Give reason/short answer.

In the given circuit diagram two resistors are connected to a 5V supply.

A third resistor is now connected in parallel with 6Ω resistor. Will the potential difference across the 8Ω resistor the larger, smaller, or the same as before? Explain the reason for your answer.


Two cells of 1.25 V and 0.75 V are connected in series with anode of one connected to anode of the other. The effective voltage will be ______.


If two bulbs of wattages 25 W and 100 W respectively each rated by 220 V are connected in series with the supply of 440 v·then which bulb will fuse?


When cells are connected in parallel, then ______


First a set of n equal resistors of R each are connected in series to a battery of emf E and internal resistance R. A current I is observed to flow. Then the n resistors are connected in parallel to the same battery. It is observed that the current is increased 10 times. What is ‘n’?


Five identical cells each of internal resistance 1Ω and emf 5V are connected in series and in parallel with an external resistance 'R'. For what value of 'R', current in series and parallel combination will remain the same?


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×