Advertisements
Advertisements
प्रश्न
It is known that density ρ of air decreases with height y as `0^(e^(y/y_0))` Where`rho_0` = 1.25 kg m–3 is the density at sea level, and y0 is a constant. This density variation is called the law of atmospheres. Obtain this law assuming that the temperature of atmosphere remains a constant (isothermal conditions). Also, assume that the value of gremains constant
उत्तर
Volume of the balloon, V = 1425 m3
Mass of the payload, m = 400 kg
Acceleration due to gravity, g = 9.8 m/s2
`y_0 = 8000m`
`rho_"He" = 0.18 kg m^(-3)`
`rho_0 = 1.25 "kg/m"^3`
Density of the balloon = ρ
Height to which the balloon rises = y
Density (ρ) of air decreases with height (y) as:
`rho = rho_0^(e^(-y/y_0))`
`rho/rho_0 = e^(-y/y_0)` ...(i)
This density variation is called the law of atmospherics.
It can be inferred from equation (i) that the rate of decrease of density with height is directly proportional to ρ, i.e.,
`-(drho)/dy prop rho`
`(drho)/dy = -krho`
`(drho)/rho = -kdy`
Where, k is the constant of proportionality
Height changes from 0 to y, while density changes from `rho_0` to ρ.
Integrating the sides between these limits, we get:
`int_(rho_0)^rho (drho)/rho = -int_0^y kdy`
`[log_e rho]_(rho_0)^rho = -ky`
`rho/rho_0 = e^(-ky)` ... (ii)
Comparing equation i and ii we get
`y_0 = 1/k`
`k= 1/y_0` ...(iii)
Fromequation i and iii we get
`rho = rho_0^(e^(-y/y_0))`
APPEARS IN
संबंधित प्रश्न
A vertical off-shore structure is built to withstand a maximum stress of 109 Pa. Is the structure suitable for putting up on top of an oil well in the ocean? Take the depth of the ocean to be roughly 3 km, and ignore ocean currents.
What is the pressure inside the drop of mercury of radius 3.00 mm at room temperature? The surface tension of mercury at that temperature (20°C) is 4.65 × 10–1 N m–1. The atmospheric pressure is 1.01 × 105 Pa. Also give the excess pressure inside the drop
A tank with a square base of area 1.0 m2 is divided by a vertical partition in the middle. The bottom of the partition has a small-hinged door of area 20 cm2. The tank is filled with water in one compartment, and an acid (of relative density 1.7) in the other, both to a height of 4.0 m. compute the force necessary to keep the door close.
In the derivation of P1 − P2 = ρgz, it was assumed that the liquid is incompressible. Why will this equation not be strictly valid for a compressible liquid?
Suppose the density of air at Madras is ρo and atmospheric pressure is P0. If we go up, the density and the pressure both decrease. Suppose we wish to calculate the pressure at a height 10 km above Madras. If we use the equation Po − P = ρogz, will we get a pressure more than the actual or less than the actual? Neglect the variation in g. Does your answer change if you also consider the variation in g?