Advertisements
Advertisements
प्रश्न
- Assertion (A): The equivalent resistance between points A and B in the given networks is 2R.
- Reason (R): All the resistors are connected in parallel.
विकल्प
Both Assertion (A) and Reason (R) are true and (R) is the correct explanation of (A).
Both Assertion (A) and Reason (R) are true and (R) is not the correct explanation of (A).
Assertion (A) is true and Reason (R) is false.
Assertion (A) is false and Reason (R) is also false.
उत्तर
Assertion (A) is true and Reason (R) is false.
Explanation:
The resistors in the following circuit are linked in both series and parallel configurations. We must simplify the circuit using the necessary criteria in order to determine the equivalent resistance between points A and B. We may reduce the circuit to a single equivalent resistor between locations A and B by applying the series and parallel rules to the resistors. The resulting equivalent resistance is:
Req = 2R
Therefore, the assertion (A) is correct, and the reason (R) is incorrect as well. All the resistors are not connected in parallel.
संबंधित प्रश्न
Each of the resistors shown in the figure has a resistance of 10 Ω and each of the batteries has an emf of 10 V. Find the currents flowing through the resistors a and bin the two circuits.
Find the equivalent resistance of the circuits shown in the figure between the points a and b. Each resistor has resistance r.
Find the current measured by the ammeter in the circuit shown in the figure.
In a meter bridge circuit, resistance in the left-hand gap is 2 Ω and an unknown resistance X is in the right-hand gap as shown in the figure below. The null point is found to be 40 cm from the left end of the Wire. What resistance should be connected to X so that the new null point is 50 cm from the left end of the wire?
A solenoid L and a resistor R are connected in series to a battery, through a switch. When the switch is put on, current I flowing through it varies with time t as shown in which of the graphs given below:
A current of 2 A flows in conductors as shown. The potential difference VA- VB will be ________.
Combine three resistors 5 Q, 4.5 Q and 3 Q in such a way that the total resistance of this combination is maximum ______.
The equivalent resistance of resistors connected in series is always ______
An electric cable of copper has just one wire of radius 9 mm. Its resistance is 14Ω. If this single copper wire of the cable is replaced by seven identical well insulated copper wires each of radius 3 mm connected in parallel, then the new resistance of the combination will be:
Three bulbs B1 (230V, 40W), B2 (230V, 60W) and B3 (230V, 100W) are connected in series to a 230V supply. Which bulb glows the brightest?
