Advertisements
Advertisements
प्रश्न
How many cubic metres of earth must be dugout to sink a well 21 m deep and 6 m diameter? Find the cost of plastering the inner surface of the well at Rs 9.50 per m2
उत्तर
Given data is as follows:
h = 21 m
Diameter = 6 m
Plastering rate = Rs.9.50/m2
We have to find the volume and the cost of plastering the inner surface of this well.
Given is the diameter, which is 6 m. Therefore,
`r=6/2`
r = 3
We know that,
Volume =`pir^2h`
=`22/7 xx 3xx3xx21`
Volume = 594 m3
We know that,
Curved Surface Area = `2pirh`
= `2 xx 22/7 xx 3 xx 21`
Curved Surface Area =396 m2
Total cost of plastering = ( Curved Surface Area ) × (Plastering rate )
=396 × 9.50
= 3762
Therefore, the volume of this well is 594 m3 and cost of plastering its inner surface is Rs.3762.
APPEARS IN
संबंधित प्रश्न
The circumference of the base of a cylinder is 88 cm and its height is 15 cm. Find its curved surface area and total surface area.
Find the volume of a cylinder whose r = 3.5 cm, h = 40 cm .
Find the volume of a cylinder, if the diameter (d) of its base and its altitude (h) are: d = 21 cm, h = 10 cm .
A well with 14 m diameter is dug 8 m deep. The earth taken out of it has been evenly spread all around it to a width of 21 m to form an embankment. Find the height of the embankment.
A solid cylinder has a total surface area of 231 cm2. Its curved surface area is \[\frac{2}{3}\] of the total surface area. Find the volume of the cylinder.
The inner diameter of a cylindrical wooden pipe is 24 cm and its outer diameter is 28 cm. The length of the pipe is 35 cm. Find the mass of the pipe, if 1 cm3 of wood has a mass of 0.6 gm.
If the height of a cylinder is doubled and radius remains the same, then volume will be ______.
A cylinder with radius r and height h is closed on the top and bottom. Which of the following expressions represents the total surface area of this cylinder?
Find the ratio of the volumes of the two cylinders formed by rolling an iron sheet 2.2m x 1.m ether along its length or by rolling along its breadth.
If the radius of a cylinder is doubled and its curved surface area is not changed, the height must be halved.