हिंदी

In a Test Experiment on a Model Aeroplane in a Wind Tunnel, the Flow Speeds on the Upper and Lower Surfaces of the Wing Are 70 M S–1and 63 M S–1 Respectively. What is the Lift on the Wing If Its Area is 2.5 M2? Take the Density of Air to Be 1.3 Kg M–3. - Physics

Advertisements
Advertisements

प्रश्न

In a test experiment on a model aeroplane in a wind tunnel, the flow speeds on the upper and lower surfaces of the wing are 70 m s–1and 63 m s–1 respectively. What is the lift on the wing if its area is 2.5 m2? Take the density of air to be 1.3 kg m–3.

उत्तर १

Speed of wind on the upper surface of the wing, V1 = 70 m/s

Speed of wind on the lower surface of the wing, V2 = 63 m/s

Area of the wing, A = 2.5 m2

Density of air, ρ = 1.3 kg m–3

According to Bernoulli’s theorem, we have the relation:

`P_1 + 1/2rhoV_1^2 = P_2 + 1/2 rhoV_2^2`

`P_2 - P_1 = 1/2 rho(V_1^2 - V_2^2)`

Where,

P1 = Pressure on the upper surface of the wing

P2 = Pressure on the lower surface of the wing

The pressure difference between the upper and lower surfaces of the wing provides lift to the aeroplane.

Lift on the wing = `(P_2 - P_1)A`

`=1/2 rho(V_1^2 - V_2^2)A`

`= 1/2 1.3((70)^2-(63)^2)xx 2.5`

= 1512.87

= 1.51 × 103 N

Therefore, the lift on the wing of the aeroplane is 1.51 × 103 N.

shaalaa.com

उत्तर २

Let v1, v2 be the speeds on the upper and lower surfaces of the wing of the aeroplane, and P1 and P2 be the pressure on upper and lower surfaces of the wing respectively.

Then `v_1 = 70 ms^(-1), v_2 = 63 ms^(-1); rho = 1.3 kg m^(-3)`

From Berniulli's theorem

`P_1/rho + gh + 1/2v_1^2 = P_2/rho + gh + 1/2 v_2^2`

`:.P_1/rho - P_2/rho = 1/2 (v_2^2 -v_1^2)`

or `P_1 -P_2 = 1/2 rho(v_2^2 - v_1^2) = 1/2 xx 1.3[(70)^2 - (63)^2] Pa = 605.15 Pa`

This difference of pressure provides the lift to the aeroplane. So lift on the aeroplane = pressiure difference x area of wing

= 605.15 x 2.5 N = 1512.875 N

= 1.15 x 103 N

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 10: Mechanical Properties of Fluids - Exercises [पृष्ठ २६९]

APPEARS IN

एनसीईआरटी Physics [English] Class 11
अध्याय 10 Mechanical Properties of Fluids
Exercises | Q 14 | पृष्ठ २६९

वीडियो ट्यूटोरियलVIEW ALL [1]

संबंधित प्रश्न

Fill in the blanks using the word(s) from the list appended with each statement

For the model of a plane in a wind tunnel, turbulence occurs at a ... speed for turbulence for an actual plane (greater / smaller)


Explain why To keep a piece of paper horizontal, you should blow over, not under, it


The cylindrical tube of a spray pump has a cross-section of 8.0 cm2 one end of which has 40 fine holes each of diameter 1.0 mm. If the liquid flow inside the tube is 1.5 m min–1, what is the speed of ejection of the liquid through the holes?


In deriving Bernoulli’s equation, we equated the work done on the fluid in the tube to its change in the potential and kinetic energy. (a) What is the largest average velocity of blood flow in an artery of diameter 2 × 10–3 m if the flow must remain laminar? (b) Do the dissipative forces become more important as the fluid velocity increases? Discuss qualitatively.


A Gipsy car has a canvass top. When the car runs at high speed, the top bulges out. Explain.


Suppose the tube in the previous problem is kept vertical with A upward but the other conditions remain the same. the separation between the cross sections at A and B is 15/16 cm. Repeat parts (a), (b) and (c) of the previous problem. Take g = 10 m/s2.


Suppose the tube in the previous problem is kept vertical with B upward. Water enters through B at the rate of 1 cm3/s. Repeat parts (a), (b) and (c). Note that the speed decreases as the water falls down.


If p0 = 1.03 × 105 Nm–2, ρ0 = 1.29 kg m–3 and g = 9.8 ms–2, at what height will the pressure drop to (1/10) the value at the surface of the earth?


In the widest part of the horizontal pipe, oil is flowing at a rate of 2 m/sec. The speed (in m/s) of the flow of oil in the narrow part of the tube if the pressure difference in the broad and narrow parts of the pipe is 0.25 ρoilg, is ______ m/s.


Calculate the velocity with which the liquid gushes out of the 4 cm2 outlet, if the liquid flowing in the tube is water and the liquid in the U tube has a specificity 12. The velocity of the liquid at point A is `sqrt20.2` m/s ______.

 


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×