Advertisements
Advertisements
प्रश्न
Suppose the tube in the previous problem is kept vertical with A upward but the other conditions remain the same. the separation between the cross sections at A and B is 15/16 cm. Repeat parts (a), (b) and (c) of the previous problem. Take g = 10 m/s2.
उत्तर
Given:
Separation between the cross sections at A and B = 15/16 cm
Speed of water at A, vA = 25 cm/s
Speed of water at B, vB = 50 cm/s
(c) By Bernoulli's equation, we get:
`1/2pv_A^2+ρgh_A+P_A=1/2pv_B^2+ρgh_B+P_B`
`=>P_A-P_B=(1/2)p(v_B^2-v_A^2)+pg(h_B-h_A) [h_A-h_B=(15/16)cm]`
`=>P_A-P_B=1/2(2500-625)-1000×15/16`
= 0
APPEARS IN
संबंधित प्रश्न
Explain why A spinning cricket ball in air does not follow a parabolic trajectory
Can Bernoulli’s equation be used to describe the flow of water through a rapid in a river? Explain.
In a test experiment on a model aeroplane in a wind tunnel, the flow speeds on the upper and lower surfaces of the wing are 70 m s–1and 63 m s–1 respectively. What is the lift on the wing if its area is 2.5 m2? Take the density of air to be 1.3 kg m–3.
The cylindrical tube of a spray pump has a cross-section of 8.0 cm2 one end of which has 40 fine holes each of diameter 1.0 mm. If the liquid flow inside the tube is 1.5 m min–1, what is the speed of ejection of the liquid through the holes?
In deriving Bernoulli’s equation, we equated the work done on the fluid in the tube to its change in the potential and kinetic energy. (a) What is the largest average velocity of blood flow in an artery of diameter 2 × 10–3 m if the flow must remain laminar? (b) Do the dissipative forces become more important as the fluid velocity increases? Discuss qualitatively.
A Gipsy car has a canvass top. When the car runs at high speed, the top bulges out. Explain.
Bernoulli's theorem is based on the conservation of
A large cylindrical tank has a hole of area A at its bottom. Water is poured in the tank by a tube of equal cross-sectional area A ejecting water at the speed v.
Suppose the tube in the previous problem is kept vertical with B upward. Water enters through B at the rate of 1 cm3/s. Repeat parts (a), (b) and (c). Note that the speed decreases as the water falls down.
What is the basis of Bernoulli’s principle?
A large number of liquid drops each of radius 'a' are merged to form a single spherical drop of radius 'b'. The energy released in the process is converted into kinetic energy of the big drop formed. The speed of the big drop is [p = density of liquid, T = surface tension of liquid] ____________.
When one end of the capillary is dipped in water, the height of water column is 'h'. The upward force of 119 dyne due to surface tension is balanced by the force due to the weight of water column. The inner circumference of the capillary is (Surface tension of water= 7 x 10-2 N/m) ____________.
Which of the following is NOT an example of the application of Bernoulli's principle?
The working of venturimeter is based on ______.
In the widest part of the horizontal pipe, oil is flowing at a rate of 2 m/sec. The speed (in m/s) of the flow of oil in the narrow part of the tube if the pressure difference in the broad and narrow parts of the pipe is 0.25 ρoilg, is ______ m/s.
Calculate the velocity with which the liquid gushes out of the 4 cm2 outlet, if the liquid flowing in the tube is water and the liquid in the U tube has a specificity 12. The velocity of the liquid at point A is `sqrt20.2` m/s ______.
A tank is filled with water of density 1 g cm-3 and oil of density 0.9 g cm3. The height of water layer is 100 cm and of the oil layer is 400 cm. If g = 980 cms-2, then the velocity of efflux from an opening in the bottom of the tank is ______.
Explain the working of an atomizer.
