Advertisements
Advertisements
प्रश्न
Set up the circuit shown in Figure again. Move the key to ‘ON’ position and watch carefully in which direction the compass needle gets deflected. Switch ‘OFF’ the current. Now keeping rest of the circuit intact, reverse the connections at the terminal of the cell. Again switch ‘on’ the current. Note the direction in which the needle gets deflected. Think of an explanation.
उत्तर
- Set up the Circuit:
- Connect the components as shown in the figure: battery, switch, wire wound around cardboard, and a compass.
- Turn the Switch 'ON':
- Close the switch to 'ON'.
- Observe and note the direction of the compass needle deflection.
- Turn the Switch 'OFF':
- Open the switch to 'OFF'.
- Reverse Battery Connections:
- Swap the positive and negative terminals of the battery.
- Turn the Switch 'ON' Again:
- Close the switch to 'ON'.
- Observe and note the direction of the compass needle deflection again.
- Explanation:
- The compass needle deflects due to the magnetic field created by the current.
- Reversing the battery connections reverses the current direction, thus reversing the magnetic field and the needle's deflection direction.
संबंधित प्रश्न
Write the condition required for a circuit to be a closed circuit.
Answer the following question.
With the help of a suitable circuit diagram prove that the reciprocal of the equivalent resistance of a group of resistances joined in parallel is equal to the sum of the reciprocals of the individual resistances.
Draw a neat diagram showing a open electric circuit.
If you touch an electric wire carrying current you get a shock, but if on the same wire the birds sit they do not get any shock/current. Explain why?
_____ has a thin metallic filament that melts and breaks the connection when the circuit is overheated.
In the following circuits (Figure), heat produced in the resistor or combination of resistors connected to a 12 V battery will be
 |
 |
 |
| (i) | (ii) | (iii) |
In an electrical circuit three incandescent bulbs A, B and C of rating 40 W, 60 W and 100 W respectively are connected in parallel to an electric source. Which of the following is likely to happen regarding their brightness?
A child has drawn the electric circuit to study Ohm’s law as shown in Figure. His teacher told that the circuit diagram needs correction. Study the circuit diagram and redraw it after making all corrections.
In the above circuit, if the current reading in the ammeter A is 2A, what would be the value of R1?
Paheli connected two bulbs to a cell as shown in Fig. 12.8.
She found that filament of bulb B is broken. Will the bulb A glow in this circuit? Give reason.
