मराठी

Monochromatic Light of Frequency 5.0 × 1014 Hz is Produced by a Laser. the Power Emitted is 3.0 × 10–3 W. Estimate the Number of Photons Emitted per Second on an Average by the Source ? - Physics

Advertisements
Advertisements

प्रश्न

Monochromatic light of frequency 5.0 × 1014 Hz is produced by a laser. The power emitted is 3.0 × 10–3 W. Estimate the number of photons emitted per second on an average by the source ?

उत्तर

Energy = hν
On an average, number of photons emitted per second  =\[\frac{\text { Power}}{\text { energy of one photon}}\]

On putting the values:
On an average, number of photons emitted per second

\[= \frac{3 \times {10}^{- 3}}{6 . 63 \times {10}^{- 34} \times 5 \times {10}^{14}}\]

\[ = 9 . 05 \times {10}^{15}\]

shaalaa.com
Refraction of Monochromatic Light
  या प्रश्नात किंवा उत्तरात काही त्रुटी आहे का?
2013-2014 (March) Delhi Set 3

संबंधित प्रश्‍न

Two monochromatic rays of light are incident normally on the face AB of an isosceles right-angled prism ABC. The refractive indices of the glass prism for the two rays '1' and '2' are respectively 1.35 and 1.45. Trace the path of these rays after entering the prism.


In the wave picture of light, the intensity of light is determined by the square of the amplitude of the wave. What determines the intensity in the photon picture of light?


State the essential conditions for diffraction of light ?


If a monochromatic source of light is replaced by white light, what change would you observe in the diffraction pattern?


Consider the situation shown in the figure. The two slits S1 and S2 placed symmetrically around the central line are illuminated by a monochromatic light of wavelength λ. The separation between the slits is d. The light transmitted by the slits falls on a screen ∑1placed at a distance D from the slits. The slit S3 is at the central line and the slit S4 is at a distance z from S3. Another screen ∑2 is placed a further distance D away from ∑1.Find the ratio of the maximum to minimum intensity observed on ∑2 if z is equal to


(a) \[z = \frac{\lambda D}{2d}\]

(b) \[\frac{\lambda D}{d}\]

(c) \[\frac{\lambda D}{4d}\]


State with reason, how the linear width of the central maximum will be affected if
(i) monochromatic yellow  light is replaced with red light, and
(ii) distance between the slit and the screen is increased.


Answer the following question.
In the diffraction due to a single slit experiment, the aperture of the slit is 3 mm. If monochromatic light of wavelength 620 nm is incident normally on the slit, calculate the separation between the first order minima and the 3rd order maxima on one side of the screen. The distance between the slit and the screen is 1.5 m.


(a) Can the interference pattern be produced by two independent monochromatic sources of light? Explain.
(b) The intensity at the central maximum (O) in Young's double-slit experimental set-up shown in the figure is IO. If the distance OP equals one-third of the fringe width of the pattern, show that the intensity at point P, would `"I"_°/4`

(c) In Young's double-slit experiment, the slits are separated by 0⋅5 mm and the screen is placed 1⋅0 m away from the slit. It is found that the 5th bright fringe is at a distance of 4⋅13 mm from the 2nd dark fringe. Find the wavelength of light used.


For constructive interference to take place between two monochromatic light waves of wavelength λ, the path difference should be ______.


A narrow slit is illuminated by a parallel beam of monochromatic light of wavelength λ equal to 6000 Å and the angular width of the central maximum in the resulting diffraction pattern is measured. When the slit is next illuminated by light of wavelength λ’, the angular width decreases by 30%. Calculate the value of the wavelength λ’.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×