Advertisements
Advertisements
प्रश्न
What should I choose ___________________
b. for getting protection from electric current.
c. to measure the current in the circuit?
उत्तर
I should choose
- Resistors in parallel for decreasing resistance in a circuit.
- Ebonite for getting protection from electric current.
- Ammeter to measure the current in the circuit.
APPEARS IN
संबंधित प्रश्न
Draw the electrical symbols of the following components and state its use
Wire crossing
What is an electric current?
One coulomb of charge flows through any cross-section of a conductor in 1 second. What is the current flowing through the conductor?
In the circuit diagram given below, three resistors R1, R2, and R3 of 5 Ω, 10 Ω and 30 Ω, respectively are connected as shown
Calculate:
- current through each resistor.
- total current in the circuit.
- total resistance in the circuit.
Draw a circuit diagram to show how two 4 V electric lamps can be lit brightly from two 2 V cells.
Ten bulbs are connected in a series circuit to a power supply line. Ten identical bulbs are connected in a parallel circuit to an identical power supply line.
(b) In which circuit, if one bulbs be brighter?
How does the heat H produced by a current passing through a fixed resistance wire depend on magnitude of current I?
Which effect of current is utilised in the working of an electric fuse?
A wire of uniform thickness with a resistance of 27Ω is cut into three equal pieces and they are joined in parallel. Find the equivalent resistance of the parallel combination.
An electric current flowing in a wire creates __________ around the wire.
Find the effective resistance in the following circuit diagrams (Fig.):
What is the function of a step-up transformer?
The circuit diagram in fig shows two coils of an insulated copper wire wound on a cardboard tube. G is a center zero galvanometer.
(a) Describe what will happen when th e swi tch K is cl osed for severa l
seconds and then opened again .
(b) What will be the effect of repeating the experiment with an iron placed in the tube?
State the S.I. units of electrical power.
An electric bulb is rated 250 W, 230 V.
- the energy consumed in one hour, and
- the time in which the bulb will consume 1.0 kWh energy when connected to 230 V mains.
Three heaters each rated 250 W, 100 V are connected in parallel to a 100 V supply of the energy supplied in kWh to the three heaters in 5 hours.
Assertion (A): Electric current will not flow between two charged bodies when connected if their charges are the same.
Reason (R): Current is the rate of flow of charge.
