Advertisements
Advertisements
Question
Solution
The parameters that can change the kinetic energy are:
(i) Mass
(ii) Speed
APPEARS IN
RELATED QUESTIONS
Look at the activity below. Reason out whether or not work is done in the light of your understanding of the term ‘work’.
A sailboat is moving due to wind energy.
Work is said to be done by a forte only when ................
No work is done by a force if the body
A vessel containing 50 kg of water is placed at a height 15 m above the ground. Assuming the gravitational potential energy at ground to be zero, what will be the gravitational potential energy of water in the vessel? (g = 10 m s-2)
How much work is done when a body of mass m is raised to a height h above the ground?
If the work done by a force in moving an object through a distance of 20 cm is 24.2 J, what is the magnitude of the force?
In which of the following case the work done by a force will be maximum : when the angle between the direction of force and direction of motion is 0° or 90°?
What is the relationship between Nm and dyne cm?
Why does a spanner have a long handle?
What is the ratio of SI units to CGS units of 'work'?
Can work done be zero even if force acts on the body?
A woman pulls a bucket of water of total mass 5 kg from a well which is 10 s. calculate the power used by her.
Define the term work. Name the CGS and SI unit of work.
State the energy changes which take place when Water stored in the dam is used to turn turbine in dynamo.
How much energy is gained by a box of mass 20 kg when a man, runs carrying the box with a speed of 3 m/s-1 to catch the bus?
State larger units of power.
A block of mass 30 kg is pulled up a slope, as shown in diagram with a constant speed, by applying a force of 200 N parallel to slope.
A and B are initial and final positions of block.
(i) Calculate the work done by force in moving the block from A to B.
(ii) Calculate P.E. gained by block. [g=10ms-2]
A truck driver can load oil drums into the back of the truck by pushing them up a sloping plank, or by lifting them directly. Each drum has a mass of 80 kg, the plank is 3 m long, and the back of the truck is 0.8 m above the ground.
(i) How much force would be needed to lift a drum into the truck directly/without using the plank? (Take g = 10 m/s2)
(ii) How much energy would be required in lifting the drum into the truck without the plank?
(iii) If the force needed to push the drum up the plank is 300 N, why is this less than the answer to part (i)?
(iv) When the truck is loaded, the driver drives off. List the major energy changes that take place in moving the truck.
(v) The driver has to stop at the factory gates. What happens to the kinetic energy of the truck?
The work done by the heart is 1 Joule per beat. Calculate the power of the heart if it beats 72 times in one
