English

Why are coils of electric toasters and electric irons made of an alloy rather than a pure metal? - Science

Advertisements
Advertisements

Question

Why are coils of electric toasters and electric irons made of an alloy rather than a pure metal?

Short Note

Solution

The resistivity of an alloy is higher than the pure metal. Moreover, at high temperatures, the alloys do not melt readily. Hence, the coils of heating appliances such as electric toasters and electric irons are made of an alloy rather than a pure metal.

shaalaa.com
  Is there an error in this question or solution?
Chapter 12: Electricity - Intext Questions [Page 209]

APPEARS IN

NCERT Science [English] Class 10
Chapter 12 Electricity
Intext Questions | Q 4 | Page 209

Video TutorialsVIEW ALL [1]

RELATED QUESTIONS

What is an Ohmic resistor?


Fill in the following blank with suitable words: 

Resistance is measured in .............. The resistance of a wire increases as the length ..............; as the temperature ..............; and as the cross-sectional area .............. .


State Ohm’s law and draw a neat labelled circuit diagram containing a battery, a key, a voltmeter, an ammeter, a rheostat and an unknown resistance to verify it. 


In a conductor 6.25 × `10^16` electrons flow from its end A to B in 2 s. Find the current flowing through the conductor (e = 1.6 × `10^-19` C)


An electric bulb draws 1.2 A current at 6.0 V. Find the resistance of filament of bulb while glowing.


In an experiment of verification of Ohm’s law following observations are obtained.

Potential difference V (in volt)

0.5 1.0 1.5 2.0 2.5
current I (in ampere) 0.2 0.4 0.6 0.8 1.0

Draw a V-I graph and use this graph to find:

  1. the potential difference V when the current I is 0.5 A,
  2. the current I when the potential difference V is 0.75 V,
  3. the resistance in a circuit.

A wire of resistance 9 ohm having length 30 cm is tripled on itself. What is its new resistance?


In the circuit shown below in Fig, calculate the value of x if the equivalent resistance between A and B is 4 Ω.


State Ohm's law. Is it always true?

What is meant by the drift speed of free electrons?


State the limitations of Ohm’s law.


Ohm’s law states the relationship between power and voltage.


Define Current density.


The resistance of a nichrome wire at 0°C is 10Ω. If its temperature coefficient of resistivity of nichrome is 0.004/ °C, find its resistance of the wire at boiling point of water. Comment on the result.


Two cells each of 5V are connected in series across an 8Ω resistor and three parallel resistors of 4Ω, 6Ω, and 12Ω. Draw a circuit diagram for the above arrangement. Calculate

  1. the current drawn from the cell
  2. current through each resistor

The slope of voltage (V) versus current (I) is called:


Two cells of same emf E but internal resistance r1 and r2 are connected in series to an external resistor R (Figure). What should be the value of R so that the potential difference across the terminals of the first cell becomes zero.


Why should an ammeter have low resistance?


A current of 0.8 A flows in a conductor of 40 Ω for 1 minute. The heat produced in the conductor will be ______.


Vinita and Ahmed demonstrated a circuit that operates the two headlights and the two sidelights of a car, in their school exhibition. Based on their demonstrated circuit, answer the following questions.

  1. State what happens when switch A is connected to:
    a) Position 2
    b) Position 3
  2. Find the potential difference across each lamp when lit.
  3. Calculate the current.
    a) in each 12 Ω lamp when lit.
    b) In each 4 Ω lamp when lit.
    OR
  4. Show, with calculations, which type of lamp, 4.0 Ω or 12 Ω, has the higher power.

Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×