हिंदी

In an alternating current circuit consisting of elements in series, the current increases on increasing the frequency of supply. Which of the following elements are likely to constitute the circuit ? - Physics

Advertisements
Advertisements

प्रश्न

In an alternating current circuit consisting of elements in series, the current increases on increasing the frequency of supply. Which of the following elements are likely to constitute the circuit?

  1. Only resistor.
  2. Resistor and an inductor.
  3. Resistor and a capacitor.
  4. Only a capacitor.

विकल्प

  • b and c

  • a and d

  • b and d

  • c and d

MCQ

उत्तर

c and d

Explanation:

This is a similar problem as we discussed above. In this problem, the current increases on increasing the frequency of supply. Hence, the reactance of the circuit must be decreased as increase in frequency. So, one element that must be connected is the capacitor. We can also connect a resistor in series.

For a capacitive circuit,

XC = 1/ωC = 1/2πfC

When frequency increases, XC decreases. Hence current in the circuit increases.

Important point: Resistive, Capacitive CIrcuit (RC - Circuit)

VR = iR,

VC = iXC,

VR = iR

  1. Applied voltage: `V = sqrt(V_R^2 + V_C^2)`
  2. Impedance: `Z = sqrt(R^2 + X_C^2) = sqrt(R^2 + (1/(ωC)^2)`
  3. Current: `i = i_0 sin(ωt + phi)`
  4. Peak current: `I_0 = V_0/Z = V_0/sqrt(R^2 + X_C^2) = V_0/sqrt(R^2 + 1/(4pi^2v^2C^2)`
  5. Phase difference: `phi = tan^-1  X_C/R = tan^-1  1/(ωCR)`
  6. Power factor: `cos phi = R/sqrt(R^2 + X_C^2)`
  7. Leading quantity: Current
shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 7: Alternating Current - MCQ I [पृष्ठ ४२]

APPEARS IN

एनसीईआरटी एक्झांप्लर Physics [English] Class 12
अध्याय 7 Alternating Current
MCQ I | Q 7.09 | पृष्ठ ४२

वीडियो ट्यूटोरियलVIEW ALL [3]

संबंधित प्रश्न

Define electric resonance.


Calculate the instantaneous value at 60°, average value and RMS value of an alternating current whose peak value is 20 A.


Why is choke coil needed in the use of fluorescent tubes with ac mains? Why can we not use an ordinary resistor instead of the choke coil?


The alternating current can be measured with the help of ______.

An inductor of inductance L, a capacitor of capacitance C and a resistor of resistance ‘R’ are connected in series to an ac source of potential difference ‘V’ volts as shown in figure. Potential difference across L, C and R is 40 V, 10 V and 40 V, respectively. The amplitude of current flowing through LCR series circuit is `10sqrt2` A. The impedance of the circuit is :


An inductor of 0.5 mH, a capacitor of 200 µF, and a resistor of 2Ω are connected in series with a 220V ac source. If the current is in phase with the emf, the frequency of ac source will be ______ × 102 Hz.


In young's double slit experiment `"d"/"D"`= 10-4 D (d = distance between slits, D = distance of screen from the slits). At a point P on the screen resulting intensity is equal to the intensity due to individual slit l0. Then the distance of point P from the central maximum is (λ = 6000 `"A"^°`)


A 50 Hz AC source of 20 volts is connected across R and C as shown in figure. The voltage across R is 12 volt. The voltage across c is ______.


An alternating current I = 14 sin (100 πt) A passes through a series combination of a resistor of 30 Ω and an inductor of `(2/(5pi))` H. Taking `sqrt2` = 1.4 calculate the rms value of the voltage drops across the resistor and the inductor.


Draw graphs showing the variations of inductive reactance and capacitive reactance with the frequency of the applied ac source.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×