Advertisements
Advertisements
प्रश्न
The electrochemical equivalent of a material depends on _______________ .
विकल्प
the nature of the material
the current through the electrolyte containing the material
the amount of charge passed through the electrolyte
the amount of this material present in the electrolyte
उत्तर
the nature of the material
The electrochemical equivalent of a substance is the ratio of the relative atomic mass of the substance to its valency. Thus, it is only dependent on the nature of the material.
APPEARS IN
संबंधित प्रश्न
A negligibly small current is passed through a wire of length 15 m and uniform cross-section 6.0 × 10−7 m2, and its resistance is measured to be 5.0 Ω. What is the resistivity of the material at the temperature of the experiment?
Two wires of equal length, one of aluminium and the other of copper have the same resistance. Which of the two wires is lighter? Hence explain why aluminium wires are preferred for overhead power cables.
(ρAl = 2.63 × 10−8 Ω m, ρCu = 1.72 × 10−8 Ω m, Relative density of Al = 2.7, of Cu = 8.9.)
What conclusion can you draw from the following observations on a resistor made of alloy manganin?
| Current A |
Voltage V |
Current A |
Voltage V |
| 0.2 | 3.94 | 3.0 | 59.2 |
| 0.4 | 7.87 | 4.0 | 78.8 |
| 0.6 | 11.8 | 5.0 | 98.6 |
| 0.8 | 15.7 | 6.0 | 118.5 |
| 1.0 | 19.7 | 7.0 | 138.2 |
| 2.0 | 39.4 | 8.0 | 158.0 |
A heating element is marked 210 V, 630 W. What is the value of the current drawn by the element when connected to a 210 V dc source?
A heating element is marked 210 V, 630 W. Find the resistance of the element when connected to a 210 V dc source.
Two wires of equal length, one of copper and the other of manganin have the same resistance. Which wire is thicker?
Plot a graph showing the variation of stopping potential with the frequency of incident radiation for two different photosensitive materials having work functions W1 and W2 (W1 > W2). On what factors does the (i) slope and (ii) intercept of the lines depend?
Two resistors A and B have resistances RA and RB, respectively, and RA < RB. The resistivities of their materials are ρA and ρB.
What length of a copper wire of cross-sectional area 0.01 mm2 will be needed to prepare a resistance of 1 kΩ? Resistivity of copper = 1.7 × 10–8 Ωm
Choose the correct alternative:
Alloys usually have much (lower/higher) temperature coefficients of resistance than pure metals.
Choose the correct alternative:
The resistivity of the alloy manganin is nearly independent of/increases rapidly with increase of temperature.
Choose the correct alternative:
The resistivity of a typical insulator (e.g., amber) is greater than that of a metal by a factor of the order of (1022/1023).
The resistivity of alloy manganin is ______.
Fuse wire should have
