मराठी

Define amplitude modulation in a communication system. - Physics

Advertisements
Advertisements

प्रश्न

Define amplitude modulation in a communication system.

एका वाक्यात उत्तर

उत्तर

In amplitude modulation, the amplitude of the carrier wave signal is varied in accordance with the information signal. We do amplitude modulation of a signal wave by superimposing it with a carrier signal. At the receiver, the signal is then demodulated by removing the carrier signal and the original data is obtained again at the receiver end.
shaalaa.com
  या प्रश्नात किंवा उत्तरात काही त्रुटी आहे का?
2018-2019 (March) 55/3/1

व्हिडिओ ट्यूटोरियलVIEW ALL [1]

संबंधित प्रश्‍न

Explain the process of amplitude modulation.


A modulating signal is a square wave, as shown

The carrier wave is given by  `c(t) = 2 sin (8pit) "volts"`

(i) Sketch the amplitude modulated waveform

(ii) What is the modulation index?


For an amplitude modulated wave, the maximum amplitude is found to be 10 V while the minimum amplitude is found to be 2 V. Determine the modulation index μ. What would be the value of μ if the minimum amplitude is zero volt?


Draw a schematic sketch showing how amplitude modulated signal is obtained by superposing a modulating signal over a sinusoidal carrier wave.


In amplitude modulation ______.


In amplitude modulation, the modulation index m, is kept less than or equal to 1 because ______.

  1. m > 1, will result in interference between carrier frequency and message frequency, resulting into distortion.
  2. m > 1 will result in overlapping of both side bands resulting into loss of information.
  3. m > 1 will result in change in phase between carrier signal and message signal.
  4. m > 1 indicates amplitude of message signal greater than amplitude of carrier signal resulting into distortion.

An amplitude modulated wave is as shown in figure. Calculate

  1. the percentage modulation
  2. peak carrier voltage and
  3. peak value of information voltage.


Draw the plot of amplitude versus ‘ω’ for an amplitude modulated wave whose carrier wave (ωc) is carrying two modulating signals, ω1 and ω22 > ω1). 

  1. Is the plot symmetrical about ωc? Comment especially about plot in region ω < ωc.
  2. Extrapolate and predict the problems one can expect if more waves are to be modulated.
  3. Suggest solutions to the above problem. In the process can one understand another advantage of modulation in terms of bandwidth?

An audio signal vm = 20sin2π(1500t) amplitude modulates a carrier vc = 80 sin 2π (100,000t). The value of percent modulation is ______.


A signal of 5 kHz frequency is amplitude modulated on a carrier wave of frequency 2 MHz. The frequencies of the resultant signal are ______. 


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×