Advertisements
Advertisements
Question
‘The current rating of a fuse is 5A’. Comment on this statement.
Solution
This statement means that the current in the circuit should not Exceed 5A. As the current in circuit will Exceed 5A, the fuse will melt and the circuit will break.
APPEARS IN
RELATED QUESTIONS
Name two safety devices which are connected to the live wire of a household electric circuit
An electric motor takes 5 amperes current form a 220 volt supply line. Calculate the power of the motor and electric energy consumed by it in 2 hours.
In a filament type light bulb, most of the electric power consumed appears as:
(a) visible light
(b) infra-red-rays
(c) ultraviolet rays
(d) fluorescent light
A geyser is rated 1500 W, 250 V. This geyer is connected to 250 V mains. Calculate:
(i) the current drawn
(ii) the energy consumed in 50 hours, and
(iii) the cost of energy consumed at Rs. 4.20 per kWh
Why is a concave reflector placed behind the heating element in a room heater.
A consumer uses 4 lamps of 60 watt, 2 lamps of 40 watt, and 2 lamps of 100 watt. All these are used for 6 hour daily. Find the total bill for 30 days when the rate of energy is 75 paise per unit and the meter rent is Rs. 1.
1 mV is equal to:
Compare the power used in the 2 Ω resistor in each of the following circuits:
- a 6 V battery in series with 1 Ω and 2 Ω resistors
- a 4 V battery in parallel with 12 Ω and 2 Ω resistors.
A room has AC run for 5 hours a day at a voltage of 220V. The wiring of the room consists of Cu of 1 mm radius and a length of 10 m. Power consumption per day is 10 commercial units. What fraction of it goes in the joule heating in wires? What would happen if the wiring is made of aluminium of the same dimensions?
`[ρ_(Cu) = 1.7 xx 10_(Ωm)^-8, ρ_(Al) = 2.7 xx 10^-8 Ωm]`
