English
Karnataka Board PUCPUC Science Class 11

Water Leaks Out from an Open Tank Through a Hole of Area 2 Mm2 in the Bottom. Suppose Water is Filled up to a Height of 80 Cm and the Area of Cross Section of the Tanks is 0.4 - Physics

Advertisements
Advertisements

Question

Water leaks out from an open tank through a hole of area 2 mm2 in the bottom. Suppose water is filled up to a height of 80 cm and the area of cross section of the tanks is 0.4 m2. The pressure at the open surface and at the hole are equal to the atmospheric pressure. Neglect the small velocity of the water near the open surface in the tank. (a) Find the initial speed of water coming out of the hole. (b) Find the speed of water coming out when half of water has leaked out. (c) Find the volume of eater leaked out using a time interval dt after the height remained is h. Thus find the decrease in height dh in terms of h and dt.
(d) From the result of park (c) find the time required for half of the water to leak out.

Sum

Solution

Given:
Area of the hole of the water tank = 2 mm2
Height of filled water, h = 80 cm
Area of the cross-section of the tanks, A = 0.4 m2
Acceleration due to gravity, g = 9.8 ms- 2

Pressure at the open surface and at the hole is equal to atmospheric pressure.

(a) Velocity of water:

V \[= \sqrt{2gh}\]

\[= \sqrt{2 \times 10 \times 0 . 80}\]

\[ = 4 m/\sec\]

(b) Velocity of water when the tank is half-filled and h \[is \frac{80}{2}, i . e . , 40 cm:\]

\[= \sqrt{2 \times 10 \times 0 . 40}\]

\[ = \sqrt{8} m/\sec\]

(c) Volume:

Volume = Ah =A v dt

\[ = A \times \sqrt{2gh} dt\]

\[ = \left( 2 {mm}^2 \right)\sqrt{2gh}dt\]

Volume of the tank = Ah = V (say)

\[i . e . , \frac{dV}{dt} = A\frac{dh}{dt}\]

\[a_1 v_1 = A\frac{dh}{dt}\]

\[ \Rightarrow 2 \times {10}^{- 6} \sqrt{2gh} = 0 . 4\frac{dh}{dt}\]

\[ \Rightarrow dh = 5 \times {10}^{- 6} \sqrt{2gh}dt\]

\[(d) \because dh = 5 \times {10}^{- 6} \sqrt{2gh}\ dt\]

\[ \therefore \frac{dh}{\sqrt{2gh}} = 5 \times {10}^{- 6}\ dt\]

On integrating, we get:

\[5 \times {10}^{- 6} \int_0^t dt = \frac{1}{\sqrt{28}} \int_{0 . 8}^{0 . 4} \frac{dh}{\sqrt{h}}\]

\[ = 5 \times {10}^{- 6} \times t = \frac{1}{\sqrt{28}} \times 2 \left[ h^\frac{1}{2} \right]_{0 . 8}^{0 . 4} \]

\[ = 5 \times {10}^{- 6} \times t = \frac{1}{\sqrt{28}} \times 2 \left[ h^\frac{1}{2} \right]_{0 . 8}^{0 . 4} \]

\[ \Rightarrow t = \frac{1}{\sqrt{20}} \times 2 \times \left[ (0 . 4 )^{1/2} - (0 . 8 )^{1/4} \right] \times \frac{1}{5 \times {10}^{- 6}}\]

\[ \Rightarrow t = \frac{1}{4 . 47} \times 2 \times \frac{2}{3 . 16} \times \frac{1}{5 \times {10}^{- 6}} \times \frac{1}{3600} h\]

\[ = 6 . 51 h\]

Thus, the time required to leak half of the water out is 6.51 hours.

shaalaa.com
  Is there an error in this question or solution?
Chapter 13: Fluid Mechanics - Exercise [Page 275]

APPEARS IN

HC Verma Concepts of Physics Vol. 1 [English] Class 11 and 12
Chapter 13 Fluid Mechanics
Exercise | Q 34 | Page 275

RELATED QUESTIONS

A U-tube contains water and methylated spirit separated by mercury. The mercury columns in the two arms are in level with 10.0 cm of water in one arm and 12.5 cm of spirit in the other. What is the specific gravity of spirit?


Does it matter if one uses gauge instead of absolute pressures in applying Bernoulli’s equation? Explain.


A manometer reads the pressure of a gas in an enclosure as shown in Figure (a) When a pump removes some of the gas, the manometer reads as in Figure (b) The liquid used in the manometers is mercury and the atmospheric pressure is 76 cm of mercury.

(a) Give the absolute and gauge pressure of the gas in the enclosure for cases (a) and (b), in units of cm of mercury.

(b) How would the levels change in case (b) if 13.6 cm of water (immiscible with mercury) are poured into the right limb of the manometer? (Ignore the small change in the volume of the gas).

 


During blood transfusion the needle is inserted in a vein where the gauge pressure is 2000 Pa. At what height must the blood container be placed so that blood may just enter the vein? [Use the density of whole blood from Table 10.1].


A one meter long glass tube is open at both ends. One end of the tube is dipped into a mercury cup, the tube is kept vertical and the air is pumped out of the tube by connecting the upper end to a suction pump. Can mercury be pulled up into the pump by this process?


A satellite revolves round the earth. Air pressure inside the satellite is maintained at 76 cm of mercury. What will be the height of mercury column in a barometer tube 1 m long placed in the satellite?


The three vessels shown in the following figure have same base area. Equal volumes of a liquid are poured in the three vessels. The force on the base will be


Figure shows a capillary tube of radius r dipped into water. If the atmospheric pressure is P0, the pressure at point A is


The surface of water in a water tank on the top of a house is 4 m above the tap level. Find the pressure of water at the tap when the tap is closed. Is it necessary to specify that the tap is closed?


The heights of mercury surfaces in the two arms of the manometer shown in figure are 2 cm and 8 cm.
Atmospheric pressure = 1.01 × 105 N−2. Find (a) the pressure of the gas in the cylinder and (b) the pressure of mercury at the bottom of the U tube.


A closed vessel is half filled with water. There is a hole near the top of the vessel and air is pumped out from this hole.
(a) The water level will rise up in the vessel.
(b) The pressure at the surface of the water will decrease
(c) The force by the water on the bottom of the vessel will decrease
(d) The density of the liquid will decrease


Suppose the glass of the previous problem is covered by a jar and the air inside the jar is completely pumped out. (a) What will be the answers to the problem? (b)  Show that the answers do not change if a glass of different shape is used provided the height, the bottom area and the volume are unchanged.


If water be used to construct a barometer, what would be the height of water column at standard atmospheric pressure (76 cm of mercury) ?


Water is filled in a rectangular tank of size 3 m × 2 m × 1 m. (a) Find the total force exerted by the water on the bottom surface on the tank. (b) Consider a vertical side of area 2 m × 1 m. Take a horizontal strip of width δx metre in this side, situated at a depth of x metre from the surface of water. Find the force by the water on this strip. (c) Find the torque of the force calculate in part (b) about the bottom edge of this side.
(d) Find the total force by the water on this side.
(e) Find the total torque by the water on the side about the bottom edge. Neglect the atmospheric pressure and take g = 10 ms−2


A U-tube containing a liquid is accelerated horizontally with a constant acceleration a0. If the separation between the vertical limbs is l, find the difference in the heights of the liquid in the two arms. 


A glass capillary sealed at the upper end is of length 0.11 m and internal diameter 2 × 10-5 m. This tube is immersed vertically into a liquid of surface tension 5.06 × 10-2 N/m. When the length x × 10-2 m of the tube is immersed in liquid then the liquid level inside and outside the capillary tube becomes the same, then the value of x is ______ m. (Assume atmospheric pressure is 1.01 × 105 `"N"/"m"^2`) 


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×