हिंदी

A .0.5m Long Solenoid of 10 Turns/Cm Has Area of Cross-section 1cm2 . Calculate the Voltage Induced Across Its Ends If the Current in the Solenoid is Changed from 1a to 2a in 0.1s. - Physics

Advertisements
Advertisements

प्रश्न

A .0.5m long solenoid of 10 turns/cm has area of cross-section 1cm2 . Calculate the voltage induced across  its ends if the current in the solenoid is changed from 1A to 2A in 0.1s. 

संख्यात्मक

उत्तर

l = 0. 5m 

n = 10 turns /cm = 10 × 10+2 turns/ m 

a = 1 cm2 = 10-4

`(di)/(dt) = (2-1)/0.1 = 1/(0.1) = 10 `A / s

     `ε = -L (di)/(dt)`

      ` = mu_0 n^2 Al (di)/(dt)`

       = 4π × 10-7 × (10+3)2 ×  10-4 × 0.5 × 10 

       = 4π × 10-7 × 106 ×  10-4 × 5 × 10-1 × 10

       ε =   20π × 10-5

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
2018-2019 (March) 55/3/3

वीडियो ट्यूटोरियलVIEW ALL [2]

संबंधित प्रश्न

A circular coil of radius 8.0 cm and 20 turns is rotated about its vertical diameter with an angular speed of 50 rad s−1 in a uniform horizontal magnetic field of magnitude 3.0 × 10−2 T. Obtain the maximum and average emf induced in the coil. If the coil forms a closed loop of resistance 10 Ω, calculate the maximum value of current in the coil. Calculate the average power loss due to Joule heating. Where does this power come from?


The closed loop (PQRS) of wire is moved into a uniform magnetic field at right angles to the plane of the paper as shown in the figure. Predict the direction of the induced current in the loop.


A rectangular metallic loop of length l and width b is placed coplanarly with a long wire carrying a current i (figure). The loop is moved perpendicular to the wire with a speed vin the plane containing the wire and the loop. Calculate the emf induced in the loop when the rear end of the loop is at a distance a from the wire. solve by using Faraday's law for the flux through the loop and also by replacing different segments with equivalent batteries.


E°cell for the given redox reaction is 2.71V
\[\ce{Mg_{(s)} +Cu^{2+}_{(0.01 M)}->Mg^{2+}_{(0.001M)}+Cu_{(s)}}\]
Calculate Ecell for the reaction. Write the direction of flow of current when an external opposite potential applied is 
(i) less than 2.71 V and
(ii) greater than 2.71 V 


The two rails of a railway track, insulated from each other and the ground, are connected to millivoltmeter. What is the reading of the millivoltmeter when a train passes at a speed of 180 km/hr along the track, given that the vertical component of earth’s magnetic field is 0.2 × 10–4 wb/m2 and rails are separated by 1 metre ______.


A moving conductor coil produces an induced e.m.f. This is in accordance with ______.

ODBAC is a fixed rectangular conductor of negilible resistance (CO is not connnected) and OP is a conductor which rotates clockwise with an angular velocity ω (Figure). The entire system is in a uniform magnetic field B whose direction is along the normal to the surface of the rectangular conductor ABDC. The conductor OP is in electric contact with ABDC. The rotating conductor has a resistance of λ per unit length. Find the current in the rotating conductor, as it rotates by 180°.


A coil of effective area 4 m2 is placed at right angles to the magnetic induction B. The e.m.f. of 0.32 V is induced in the coil. When the field is reduced to 20% of its initial value in 0.5 sec. Find B (in wb/m2).


The self induced emf of a coil is 25 volts. When the current in it is changed at uniform rate from 10 A to 25 A in 1 s, the change in the energy of the inductance is ______.


A square-shaped coil of side 10 cm, having 100 turns is placed perpendicular to a magnetic field which is increasing at 1 T/s. The induced emf in the coil is ______.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×