Advertisements
Advertisements
प्रश्न
A rectangular wire loop of sides 8 cm and 2 cm with a small cut is moving out of a region of uniform magnetic field of magnitude 0.3 T directed normal to the loop. What is the emf developed across the cut if the velocity of the loop is 1 cm s−1 in a direction normal to the
- longer side,
- shorter side of the loop?
For how long does the induced voltage last in each case?
उत्तर
Magnetic flux passing through an area A placed perpendicular to the magnetic field B is Φ = BA.
Let the length of the loop be l and width b and the magnitude of its velocity be. As soon as the loop is taken out of the magnetic field perpendicular to the longer side, the area bounded by the field changes, which leads to a change in From Faraday's law, the magnitude of the induced electromotive force is
|e| = `"dΦ"/"dt"`
= `"d"/"dt"("BA")`
= `"B" ("dA"/"dt")`
Now, `"dA"/"dt"` = lv ....(Area enclosed by the loop per second)
Hence, |e| = Blv = 0.3 weber/m2 × (8 × 10-2 m) × (10-2 m/s)
= 2.4 × 10-4 weber/second
= 2.4 × 10-4 Volt
= 0.24 millivolts
The induced potential difference will remain as long as the flux changes. Thus, the time for the potential difference |e| to persist
= `"b"/"v"`
= `(2 xx 10^-2 "m")/(10^-2 "m/s")`
= 2 s
From figure (b), `"dA"/"dT" = "bv"`
|e| = Bbv
= 0.3 × (2 × 10-2) × 10-2
= 0.6 × 10-4 volt
= 0.06 millivolt
|e| the duration of the = `l/v`
= `(8 xx 10^-2 "m")/(10^-2 "m/s")`
= 8 s
APPEARS IN
संबंधित प्रश्न
State Fleming’s right-hand rule.
The magnetic flux through a loop is varying according to a relation `phi = 6t^2 + 7t + 1` where `phi` is in milliweber and t is in second. What is the e.m.f. induced in the loop at t = 2 second?
What is electromagnetic induction?
State three ways in which the strength of an electromagnet can be increased.
How does an electromagnet differ forma permanent magnet?
Name two devices in which electromagnets are used and two devices where permanent magnets are used.
State the factors on which the strength of an electromagnet depends. How does it depend on these factors?
State whether the following statement are true or false:
A motor works on the principle electric generator?
Name one device which works on the phenomenon of electromagnetic induction.
Describe different ways to induce current in a coil of wire.
In which of the following case does the electromagnetic induction occur?
A magnet is moved through a loop of wire .
Electromagnetic induction means ______.
A conducting rod is moved with a constant velocity v in a magnetic field. A potential difference appears across the two ends _____________ .
Complete the following diagram of a transformer and name the parts labeled A and B. Name the part you have drawn to complete the diagram . What is the material of this part? In this transformer a step-up or step-down? Why?
A coil of 200 turns carries a current of 4 A. If the magnetic flux through the coil is 6 x 10-5 Wb, find the magnetic energy stored in the medium surrounding the coil.
A cylindrical bar magnet (A) and similar unmagnetized cylindrical iron bar (B) are dropped through metallic pipe. The time taken to come down by ____________.
Ansari Sir was demonstrating an experiment in his class with the setup as shown in the figure below.
A magnet is attached to a spring. The magnet can go in and out of the stationary coil. He lifted the Magnet and released it to make it oscillate through the coil.
Based on your understanding of the phenomenon, answer the following question.
Consider the situation where the Magnet goes in and out of the coil. State two changes which could be made to increase the deflection in the galvanometer.
Which of the following phenomena makes use of electromagnetic induction?
A rectangular, a square, a circular and an elliptical loop, all in the (x - y) plane, are moving out of a uniform magnetic field with a constant velocity `vecv = vhati`. The magnetic field is directed along the negative z-axis direction. The induced emf, during the passage of these loops, out of the field region, will not remain constant for ______.
In the given circuit, initially switch S1 is closed and S2 and S3 are open. After charging of capacitor, at t = 0, S1 is open and S2 and S3 are closed. If the relation between inductance capacitance and resistance is L = 4CR2 then the time (in sec) after which current passing through capacitor and inductor will be same is ______ × 10-4 N. (Given R = ℓn(2)mΩ, L = 2mH)
