Advertisements
Advertisements
प्रश्न
A series AC circuit has a resistance of 4 Ω and a reactance of 3 Ω. The impedance of the circuit is
विकल्प
5 Ω
7 Ω
12/7 Ω
7/12 Ω
उत्तर
5 Ω
The impedance of the circuit is given by
`Z =sqrt(R^2+ X^2`
`R =4Ω&X=3Ω`
`⇒ Z=sqrt4^2 + 3^2 = 5_Ω`
APPEARS IN
संबंधित प्रश्न
In a series LR circuit, XL = R and power factor of the circuit is P1. When capacitor with capacitance C such that XL = XC is put in series, the power factor becomes P2. Calculate P1/P2
A lamp is connected in series with an inductor and an AC source. What happens to the brightness of the lamp when the key is plugged in and an iron rod is inserted inside the inductor? Explain.
An alternating emf of 220 V is applied to a circuit containing a resistor R having the resistance of 160Ω and a capacitor ‘C’ is series. The current is found to lead the supply voltage by an angle
`θ = tan^(-1) ("3/4")`
a) Calculate
1) The capacitive reactance
2) The impedance of the circuit
3) Current flowing in the circuit
b) If the frequency of the applied emf is 50 Hz, what is the value of the capacitance of the capacitor ‘C’?
The power factor of an a.c. circuit is 0.5. What is the phase difference between voltage and current in this circuit ?
For a given a.c., i = im sin ωt, show that the average power dissipated in a resistor R over a complete cycle is `1/2I_m^2` R .
In a circuit, containing a capacitor and an AC source, the current is zero at the instant the source voltage is maximum. Is it consistent with Ohm's Law?
An AC source rated 100 V (rms) supplies a current of 10 A (rms) to a circuit. The average power delivered by the source
(a) must be 1000 W
(b) may be 1000 W
(c) may be greater than 1000 W
(d) may be less than 1000 W
An electric bulb is designed to consume 55 W when operated at 110 volts. It is connected to a 220 V, 50 Hz line through a choke coil in series. What should be the inductance of the coil for which the bulb gets correct voltage?
In a series LCR circuit with an AC source, R = 300 Ω, C = 20 μF, L = 1.0 henry, εrms = 50 V and ν = 50/π Hz. Find (a) the rms current in the circuit and (b) the rms potential difference across the capacitor, the resistor and the inductor. Note that the sum of the rms potential differences across the three elements is greater than the rms voltage of the source.
At a hydroelectric power plant, the water pressure head is at a height of 300 m and the water flow available is 100 m3 s–1. If the turbine generator efficiency is 60%, estimate the electric power available from the plant (g = 9.8 ms–2).
In which of the following circuits the maximum power dissipation is observed?
The power factor of series LCR circuit when at resistance is
The series combination of R, L, C is connected to an a.c. source. If the resistance is 3 and the reactance is 4, the power factor of the circuit is:
In an AC. circuit, the current is :
i = `5 sin (100t - pi/2)` amp.
and the a.c. potentiol is:
V = 200 sin (100t) volt.
Then the power consumption is
In the series LCR circuit, the power dissipation is through ______
The coefficient of induction of a choke coil is 0.1 H and resistance is 12 Ω. If it is connected to an a.c source of frequency 60Hz. Then the power factor will be ______.
An alternating current generator has an internal resistance Rg and an internal reactance Xg. It is used to supply power to a passive load consisting of a resistance Rg and a reactance XL. For maximum power to be delivered from the generator to the load, the value of XL is equal to ______.
An inductor of reactance 1 Ω and a resistor of 2 Ω are connected in series to the terminals of a 6 V (rms) a.c. source. The power dissipated in the circuit is ______.
