Advertisements
Advertisements
प्रश्न
A coil has a resistance of 10 Ω and an inductance of 0.4 henry. It is connected to an AC source of 6.5 V, `30/pi Hz`. Find the average power consumed in the circuit.
उत्तर
Given:
Resistance of coil, R = 10 Ω
Inductance of coil, L = 0.4 Henry
Voltage of AC source, Erms = 6.5 V
Frequency of AC source, `f = 30/pi Hz`
Reactance of resistance-inductance circuit (Z) is given by,
`Z = sqrt(R^2 + X_L^2`
Here, R = resistance of the circuit
XL = Reactance of the pure inductive circuit
`Z = sqrt(R^2 + (2pifL)^2`
Average power consumed in the circuit (P) is given by,
`P = E_{rms}l_{rms}cosØ`
`therefore P = 6.5 xx 6.5/Z xx R/Z`
⇒ P = `(6.5xx6.5xx10)/((sqrt(R^2 +(omegaL)^2))`
⇒ P =` (6.5xx6.5xx10)/(100 + 576)`
⇒ `P= (6.5xx6.5xx10)/(676)`
⇒ `P = 0.625 = 5/8 W`
APPEARS IN
संबंधित प्रश्न
An a.c. source of voltage V = V0 sin ωt is connected to a series combination of L, C, and R. Use the phasor diagram to obtain the expression for an impedance of a circuit and the phase angle between voltage and current. Find the condition when current will be in phase with the voltage. What is the circuit in this condition called?
When an AC source is connected to an ideal inductor show that the average power supplied by the source over a complete cycle is zero.
A lamp is connected in series with an inductor and an AC source. What happens to the brightness of the lamp when the key is plugged in and an iron rod is inserted inside the inductor? Explain.
An A.C. generator generating an emf of ε = 300 sin (100 πt) V is connected to a series combination of 16μ F capacitor, 1 H inductor and 100 Ω resistor.
Calculate :
1) An impedance of the circuit at the given frequency.
2) Resonant frequency `f_0`
3)Power factor at the resonant frequency `f_0`.
An AC source rated 100 V (rms) supplies a current of 10 A (rms) to a circuit. The average power delivered by the source
(a) must be 1000 W
(b) may be 1000 W
(c) may be greater than 1000 W
(d) may be less than 1000 W
The current in a discharging LR circuit is given by i = i0 e−t/τ , where τ is the time constant of the circuit. Calculate the rms current for the period t = 0 to t = τ.
An electric bulb is designed to consume 55 W when operated at 110 volts. It is connected to a 220 V, 50 Hz line through a choke coil in series. What should be the inductance of the coil for which the bulb gets correct voltage?
Following figure shows a typical circuit for a low-pass filter. An AC input Vi = 10 mV is applied at the left end and the output V0 is received at the right end. Find the output voltage for ν = 10 k Hz, 1.0 MHz and 10.0 MHz. Note that as the frequency is increased the output decreases and, hence, the name low-pass filter.
What is the value of power factor for a pure resistor connected to an alternating current source ?
An ac circuit as shown in the figure has an inductor of inductance L and a resistor of resistance R connected in series. Using the phasor diagram, explain why the voltage in the circuit will lead the current in phase.
Suppose the circuit has a resistance of 15 Ω. Obtain the average power transferred to each element of the circuit, and the total power absorbed.
Quality factor and power factor both have the dimensions of ______.
Which of the following quantities remains constant in a step-down Transformer?
The power factor of an a.c circuit having resistance R and inductance L Connected in series to an a.c source of angular frequency co is.
The coefficient of induction of a choke coil is 0.1 H and resistance is 12 Ω. If it is connected to an a.c source of frequency 60Hz. Then the power factor will be ______.
An alternating current generator has an internal resistance Rg and an internal reactance Xg. It is used to supply power to a passive load consisting of a resistance Rg and a reactance XL. For maximum power to be delivered from the generator to the load, the value of XL is equal to ______.
