Advertisements
Advertisements
प्रश्न
In a meter bridge circuit, resistance in the left-hand gap is 2 Ω and an unknown resistance X is in the right-hand gap as shown in the figure below. The null point is found to be 40 cm from the left end of the Wire. What resistance should be connected to X so that the new null point is 50 cm from the left end of the wire?
उत्तर
According to Fig.
`2/X = 40/(100-40) = 4/6`
X = 3 Ω
Let R Ω be connected with X in parallel to obtain the null point at 50 cm from left.
Now, if S Ω be in equivalent resistance of X and R then,
`2/S = 50/(100-50) = 1`
∴ S = 2 Ω
Now, to obtain 2 Ω as equivalent resistance between X and R, we have
`1/2 = 1/3 +1/R`
∴ R = 6 Ω
∴ 6 Ω resistance is to be connected in parallel to X.
APPEARS IN
संबंधित प्रश्न
A uniform wire of resistance 50 Ω is cut into 5 equal parts. These parts are now connected in parallel. The equivalent resistance of the combination is ______________ .
Find the current measured by the ammeter in the circuit shown in the figure.
The voltmeter shown in the figure reads 18 V across the 50 Ω resistor. Find the resistance of the voltmeter.
An ammeter is to be constructed that can read currents up to 2.0 A. If the coil has resistance of 25 Ω and takes 1 mA for full-scale deflection, what should be the resistance of the shunt used?
A voltmeter coil has resistance 50.0 Ω and a resistor of 1.15 kΩ is connected in series. It can read potential differences up to 12 volts. If this same coil is used to construct an ammeter that can measure currents up to 2.0 A, what should be the resistance of the shunt used?
The figure shows three conductors I, II and III of same material, different lengths l, 2l and 3l and of different areas of cross-sections 3A, A and 2A respectively. Arrange them in the increasing order of current drawn from the battery.
How many times will the resistance of an identical conductor be increase, if the parallel resistance be change to series one?
The effective resistance of a parallel connection that consists of four wires of equal length, equal area of cross-section and the same material is 0.25 Ω. What will be the effective resistance if they are connected in series?
Let there be n resistors R1............Rn with Rmax = max (R1......... Rn) and Rmin = min {R1..... Rn}. Show that when they are connected in parallel, the resultant resistance RP < R min and when they are connected in series, the resultant resistance RS > Rmax. Interpret the result physically.
