Advertisements
Advertisements
प्रश्न
A resistance is connected to an AC source. If a capacitor is included in the series circuit, will the average power absorbed by the resistance increase or decrease? If an inductor of small inductance is also included in the series circuit, will the average power absorbed increase or decrease further?
उत्तर
When a capacitor is included in a series circuit, the impedance of the circuit,
`Z =sqrt(R^2 + Xc^2`
The power absorbed by a resistor is given by,
`P = Irms^2R`
Since impedance increases due to introduction of a capacitor, the rms value of current Irms will decrease and, hence, the power absorbed by the resistor will decrease.
When a small inductance is introduced in the circuit, the impedance of the circuit,
`Z = sqrt(R^2 + (X_c - X_L)^2`
Since the impedance now decreases a little, the rms value of current will increase and, hence, the power absorbed by the resistor will increase.
APPEARS IN
संबंधित प्रश्न
An a.c. source of voltage V = V0 sin ωt is connected to a series combination of L, C, and R. Use the phasor diagram to obtain the expression for an impedance of a circuit and the phase angle between voltage and current. Find the condition when current will be in phase with the voltage. What is the circuit in this condition called?
When an AC source is connected to an ideal inductor show that the average power supplied by the source over a complete cycle is zero.
A lamp is connected in series with an inductor and an AC source. What happens to the brightness of the lamp when the key is plugged in and an iron rod is inserted inside the inductor? Explain.
Prove theoretically the relation between e.m.f. induced in a coil and rate of change of magnetic flux in electromagnetic induction.
Define the quality factor in an a.c. circuit. Why should the quality factor have high value in receiving circuits? Name the factors on which it depends.
A series AC circuit has a resistance of 4 Ω and a reactance of 3 Ω. The impedance of the circuit is
An AC source rated 100 V (rms) supplies a current of 10 A (rms) to a circuit. The average power delivered by the source
(a) must be 1000 W
(b) may be 1000 W
(c) may be greater than 1000 W
(d) may be less than 1000 W
A coil has a resistance of 10 Ω and an inductance of 0.4 henry. It is connected to an AC source of 6.5 V, `30/pi Hz`. Find the average power consumed in the circuit.
Following figure shows a typical circuit for a low-pass filter. An AC input Vi = 10 mV is applied at the left end and the output V0 is received at the right end. Find the output voltage for ν = 10 k Hz, 1.0 MHz and 10.0 MHz. Note that as the frequency is increased the output decreases and, hence, the name low-pass filter.
An ac circuit as shown in the figure has an inductor of inductance L and a resistor of resistance R connected in series. Using the phasor diagram, explain why the voltage in the circuit will lead the current in phase.
Answer the following question.
Show that an ideal inductor does not dissipate power in an ac circuit.
Quality factor and power factor both have the dimensions of ______.
Which of the following quantities remains constant in a step-down Transformer?
The series combination of R, L, C is connected to an a.c. source. If the resistance is 3 and the reactance is 4, the power factor of the circuit is:
A 100 Ω electric iron is connected to 200 V, 50 Hz ac source. Calculate average power delivered to iron, peak power and energy spent in one minute?
In the series LCR circuit, the power dissipation is through ______
The coefficient of induction of a choke coil is 0.1 H and resistance is 12 Ω. If it is connected to an a.c source of frequency 60Hz. Then the power factor will be ______.
