Advertisements
Advertisements
प्रश्न
What are phasors?
उत्तर
A sinusoidal alternating voltage (or current) can be represented by a vector which rotates about the origin in an anti-clockwise direction at a constant angular velocity ω. Such a rotating vector is called a phasor.
APPEARS IN
संबंधित प्रश्न
An inductor 20 mH, a capacitor 50 μF and a resistor 40Ω are connected in series across a source of emf V = 10 sin 340 t. The power loss in AC circuit is
What do you mean by resonant frequency?
The rms value of potential difference V shown in the figure is ______.
In an alternating current circuit consisting of elements in series, the current increases on increasing the frequency of supply. Which of the following elements are likely to constitute the circuit?
- Only resistor.
- Resistor and an inductor.
- Resistor and a capacitor.
- Only a capacitor.
An inductor of 0.5 mH, a capacitor of 200 µF, and a resistor of 2Ω are connected in series with a 220V ac source. If the current is in phase with the emf, the frequency of ac source will be ______ × 102 Hz.
In young's double slit experiment `"d"/"D"`= 10-4 D (d = distance between slits, D = distance of screen from the slits). At a point P on the screen resulting intensity is equal to the intensity due to individual slit l0. Then the distance of point P from the central maximum is (λ = 6000 `"A"^°`)
The r.m.s. value of alternating current is 10 A, having frequency of 50 Hz. The time taken by the current to increase from zero to maximum and the maximum value of current will be ______.
A 50 Hz AC source of 20 volts is connected across R and C as shown in figure. The voltage across R is 12 volt. The voltage across c is ______.
A direct current of 4 A and an alternating current of peak value 4 A flow through resistance of 3Ω and 2Ω respectively. The ratio of heat produced in the two resistances in same interval of time will be ______.
A series CR circuit with R = 200 Ω and C = (50/π) µF is connected across an ac source of peak voltage ε0 = 100 V and frequency v = 50 Hz. Calculate (a) impedance of the circuit (Z), (b) phase angle (Φ), and (c) voltage across the resistor.
