Advertisements
Advertisements
प्रश्न
In a series LCR circuit with an AC source, R = 300 Ω, C = 20 μF, L = 1.0 henry, εrms = 50 V and ν = 50/π Hz. Find (a) the rms current in the circuit and (b) the rms potential difference across the capacitor, the resistor and the inductor. Note that the sum of the rms potential differences across the three elements is greater than the rms voltage of the source.
उत्तर
Given:
Resistance in series LCR circuit, R = 300 Ω
Capacitance in series LCR circuit, C = 20 μF= 20 × 10−6 F
Inductance in series LCR circuit, L = 1 Henry
RMS value of voltage, εrms = 50 V
Frequency of source, f = 50/ ` pi`Hz
Reactance of the inductor (XL) is given by,
`X_C = omegaL = 2pifL`
`rArr X_C = 500 Ω`
(a) Impedance of an LCR circuit (Z) is given by,
`Z = sqrt(R^2 + (X_C - X_L )^2 `
`rArr Z = sqrt((300)^2 + (500 - 100)^2`
`rArr Z = sqrt((300)^2 + (400)^2`
⇒ Z = 500
RMS value of current Irms is given
`I_{rms} = epsilon_{rms}/Z`
`rArr I_{rms} = 50/500`
`rArr I_{rms} = 0.1A`
(b) Potential across the capacitor `(V_C)` is given by,
`V_C = I_{rms} xx X_C`
`rArr V_C = 0.1xx500 = 50V`
Potential difference across the resistor `(V_R)` is given by
`V_R =I_{rms}xxR`
`V_R = 0.1xx300xx = 30V`
Potential difference across the inductor `(V_L)` is given by,
`V_L = I_{rms]xxXL`
` rArr V_L =0.1xx100 = 10V `
R.M.s potential = 50V
Net sum of all the potential drops = 50 V + 30 V + 10 V = 90 V
Sum of the potential drops > RMS potential applied
APPEARS IN
संबंधित प्रश्न
An a.c. source of voltage V = V0 sin ωt is connected to a series combination of L, C, and R. Use the phasor diagram to obtain the expression for an impedance of a circuit and the phase angle between voltage and current. Find the condition when current will be in phase with the voltage. What is the circuit in this condition called?
When an AC source is connected to an ideal inductor show that the average power supplied by the source over a complete cycle is zero.
In a series LR circuit, XL = R and power factor of the circuit is P1. When capacitor with capacitance C such that XL = XC is put in series, the power factor becomes P2. Calculate P1/P2
A lamp is connected in series with an inductor and an AC source. What happens to the brightness of the lamp when the key is plugged in and an iron rod is inserted inside the inductor? Explain.
An alternating emf of 220 V is applied to a circuit containing a resistor R having the resistance of 160Ω and a capacitor ‘C’ is series. The current is found to lead the supply voltage by an angle
`θ = tan^(-1) ("3/4")`
a) Calculate
1) The capacitive reactance
2) The impedance of the circuit
3) Current flowing in the circuit
b) If the frequency of the applied emf is 50 Hz, what is the value of the capacitance of the capacitor ‘C’?
In a circuit, containing a capacitor and an AC source, the current is zero at the instant the source voltage is maximum. Is it consistent with Ohm's Law?
A resistance is connected to an AC source. If a capacitor is included in the series circuit, will the average power absorbed by the resistance increase or decrease? If an inductor of small inductance is also included in the series circuit, will the average power absorbed increase or decrease further?
A series AC circuit has a resistance of 4 Ω and a reactance of 3 Ω. The impedance of the circuit is
In an AC series circuit, the instantaneous currt is zero when the instantaneous voltage is maximum. Connected to the source may be a
(a) pure inductor
(b) pure capacitor
(c) pure resistor
(d) combination of an inductor and a capacitor
A coil has a resistance of 10 Ω and an inductance of 0.4 henry. It is connected to an AC source of 6.5 V, `30/pi Hz`. Find the average power consumed in the circuit.
Consider the situation of the previous problem. Find the average electric field energy stored in the capacitor and the average magnetic field energy stored in the coil.
Following figure shows a typical circuit for a low-pass filter. An AC input Vi = 10 mV is applied at the left end and the output V0 is received at the right end. Find the output voltage for ν = 10 k Hz, 1.0 MHz and 10.0 MHz. Note that as the frequency is increased the output decreases and, hence, the name low-pass filter.
Suppose the circuit has a resistance of 15 Ω. Obtain the average power transferred to each element of the circuit, and the total power absorbed.
The series combination of R, L, C is connected to an a.c. source. If the resistance is 3 and the reactance is 4, the power factor of the circuit is:
In an AC. circuit, the current is :
i = `5 sin (100t - pi/2)` amp.
and the a.c. potentiol is:
V = 200 sin (100t) volt.
Then the power consumption is
The coefficient of induction of a choke coil is 0.1 H and resistance is 12 Ω. If it is connected to an a.c source of frequency 60Hz. Then the power factor will be ______.
An inductor of reactance 1 Ω and a resistor of 2 Ω are connected in series to the terminals of a 6 V (rms) a.c. source. The power dissipated in the circuit is ______.